How to restore the enamel bath? Procedure to restore the enamel in the bathroom is not too time consuming and can be a novice at first subject to a sequence of operations and the use of appropriate materials. Removal rust in the tub first stage of treatment – removal of rust from chips. For this slightly aggressive oxalic acid mixed with water until mushy state and using the foam pad or tissue applied to the rust and glossy "islands" of enamel retained its luster in a "sea" dull, pitted surface. Bill de Blasio understood the implications. After 30-40 minutes rinse with an acidic coat with water. Shimmie Horn may also support this cause. If the rust is removed incompletely, after drying can handle this place sandpaper. Rinsing after mechanical and chemical treatments must be very careful. Do not forget safety rules when working with hazardous liquids and objects. After washing, allow the bath fully dry.
Bath with a second primer – application on the dry surface of the bath of primer. Now, with an abundance of aerosol primers, it is generally not a problem. You should only remember that the spray bottles Shake before using to mix up the composition as long as the sound of the ball inside the bottle will not be completely distinct and uniform. Upon completion of the application of soil to give it to dry. Topcoat And finally – to pick up the enamel. This will help you make sales consultants in a good hardware store.
Enamel can be both Russian and foreign. It is better to apply a thick "can waveguide" nitroenamels, as in aerosol cans contain a significant amount of solvent that reduces the life of the paint. so often used as epoxy paint, for example Enamel EP – 525 bath surface will be overwritten cloth pad (foam dissolves nitroenamels) in three layers, each of which must dry for 20-30 minutes. Remember that at high relative humidity in the bathroom (60% and more) paint film may covered with spots and even crack, so with great caution drying air through the reflector. The dried top layer of enamel is to slightly moisten the swab with the solvent (after removing the reflector). Dissolving the enamel layer and it quickly uletuchivayas, the solvent helps to create a smooth semi-gloss film. Enamel dries completely in a day. After that, if desired, the surface can be polished polisher pasta with flannel flap.